Description Of The Appliance; Switching On The Appliance; Shot Of Steam - ARIETE ECO POWER 6430 Manual Del Usuario

DescrIpTIOn Of The ApplIAnce

A - Tank
B - Anti-scale cartridge
C - Tank cover
D - Iron support grid
E - Appliance carrying handle
F - Continuous steam lock slider
G - Steam button
InsTrucTIOns fOr use
Warning!
remove any labels and protections from the soleplate before using the appliance for the first time.
Place the appliance on a stable even surface (e.g. a table or an ironing board).
The first two times the tank is filled, always use normal tap water without using the anti-scale cartridge (B). Then it will be
necessary to use tap water demineralized by the anti-scale cartridge (B) or distilled water.
open the tank by removing the lid (C). release the anti-scale cartridge (B) from the protective cap Fig. 2. Insert the anti-
scale cartridge into the tank (Fig. 3).
Warning!
Take care that the red arrow on the cartridge is facing in the direction of the corresponding arrow positioned above
the appliance tank (Fig. 3).
Press lightly until the cartridge has reached the end of its housing.
The anti-scale cartridge purifies water from substances harmful to the iron, therefore it allows to use ordinary tap water. The
anti-scale cartridge must be replaced when the resins contained therein have completely changed colour. The replacement
cartridges are available at the sale points or in Authorized Service Centers.
filling the tank before use
Warning!
Make sure the unit has been disconnected from the mains supply before filling the tank (A) with water.
open the tank lid (C). Fill the tank with cool tap water (Fig. 4). Close the tank lid (C).
neVer fill the tank beyond the maX level.
Warning!
To avoid damaging the pump, never operate the appliance without any water in the tank, even for dry ironing.

switching on the appliance

Before plugging it in, completely unwind the power cord. Connect the appliance to the power supply, ensuring that the volt-
age indicated on the identification plate corresponds to your local power supply.
Before you turn on the appliance, make sure there is sufficient water inside the tank.
Press the iron-boiler power switch (L) Fig. 6. Place the temperature control knob (H) to the desired temperature. on first use,
after filling the tank, it is necessary to adjust the temperature control knob (H) over the symbol (
button (G) Fig. 7 until the iron does not produce steam (about one minute) Fig. 9. The iron is now ready for use.
Before applying a jet of steam to the article to be ironed, release two or three good jets of steam towards the floor to stabilise
the steam flow.
Warning!
Do not release steam when the iron is standing on its grille rest (D).
The iron is fed automatically by means of a pump that at each filling is activated for a few seconds by generating a normal
operation sound (vibration). A decrease in the steam output may occur soon after the pump starts operating: it is perfectly
normal and after a few seconds the steam will again be regular.
If the iron has not been used for a long time, it is advisable to keep it in a horizontal position and send a few shots of steam
to the floor in order to stabilize the jet before ironing.

shot of steam

Set the ironing temperature by turning the adjustment knob (H) past the symbol (
iron to turn off. Press the steam button (G) from 3 to 5 seconds (Fig. 7). An intense jet of steam will be dispensed when at the
button release. If the steam supply button (G) is operated continuously for more than 30 seconds, drops of water may come
from the steam holes in the plate of the iron. It is recommended that the button (G) is used for shorter periods.
12
H - Temperature adjustment knob
I - Iron temperature control indicator light
J - Soleplate
K - Power cord
L - Iron/boiler on-off switch
M - Iron/boiler connection cable
N - Cable compartment
•••
). Wait for the indicator lamp (I) of the
•••
) and press the steam