Vertical Ironing - ARIETE ECO POWER 6430 Manual Del Usuario

continuous steam
Set the ironing temperature by turning the adjustment knob (H) past the symbol (
iron to turn off. When the temperature is reached, press the steam button (G) Fig. 8. The cursor (F) will lock the button,
making the jet of steam exit continuously and steadily. To unlock the button (G) and stop the continuous jet, press the cursor
(F) forward (Fig. 10).
Temperature selection
First check whether the fabric has a label containing ironing instructions and compare the symbol with the instructions which
follow. If there is no label with instructions, but you know the type of material, follow the instructions below.
Note that the table refers to fabrics not treated with sizing agents or similar products; if they have been, you can also iron
at a lower temperature.
When you change the temperature by turning the adjustment knob (H), the light (I) will turn on and stay on until the iron
reaches the new temperature.
filling the boiler during use
always check the level of water in the tank while you are ironing.
add enough water to the tank so that the water level is always visible. do not go past the maX level.
If the tank remains without water, you will notice a vibration and a louder noise. Turn off the appliance by pressing the switch
(L). unplug it from the electric outlet. Add water directly in the tank (Fig. 4).
Warning!
Always turn off the appliance and remove the power cable plug from the socket-outlet before filling the tank with
water.
Warning!
In the absence of the anti-scale cartridge refill the tank with demineralized water.
Insert the plug into the electrical outlet and turn on the appliance again.
If the appliance is not switched off promptly, overheating of the pump could cause a momentary stoppage of the appliance.
Therefore it is necessary to switch off the appliance and fill the tank. Wait about an hour for the appliance to cool down and
resumes normal operation.
Dry ironing
Dry (that is, steam less) ironing is obtained by plugging in the appliance, turning on the iron by means of switch (L), and
setting thermostat knob (H) on the desired temperature. Do not press the steam button.

vertical ironing

You can use the jet of continuous steam for ironing hanging fabrics. This special ironing procedure serves to remove
creases from curtains, fabrics, etc. Set the ironing temperature by turning the adjustment knob (H) past the symbol (
Put the curtain or fabric in the position you want to iron it vertically and press the steam button.
Warning!
Do not iron fabrics held by other people.
After ironing
Turn off the appliance by pressing the switch (L). remove the power cable from the socket-outlet. replace the power cord
and the iron-boiler connecting cable in the cord storage compartment (N). Let the iron cool down on its stand, taking care
not to touch the power cables and connection with the hot parts of the appliance.
suggesTIOns
Divide the articles to be ironed according to the types of material: wool with wool, cotton with cotton, etc
Because the iron heats up much more quickly than it cools down, it is advisable to start with those fabrics which require
lower temperatures and move on to those which require progressively higher temperatures. If the material is made up of
more than one type of fibre, always set the temperature to the fibre which requires less heat. For example, if the material
is made up of 70% synthetics and 30% cotton, set the temperature control to position (
the temperature for synthetic fabrics.
•••
). Wait for the indicator lamp (I) of the
•
) (see table) without steam, that is,
•••
).
13