DeWalt DW402 Manual De Instrucciones página 10

MOUNTING AND REMOVING HUBBED WHEELS
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
Hubbed wheels install directly on the 5/8"–11 threaded spindle.
1. Thread the wheel on the spindle by hand.
2. Depress the spindle lock button and use a wrench to tighten the
hub of the wheel.
3. Reverse the above procedure to remove the wheel.
CAUTION: Failure to properly seat the wheel before turning the
tool on may result in damage to the tool or the wheel.
MOUNTING NON-HUBBED WHEELS
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
Depressed center, Type 27 grinding wheels
must be used with included flanges. Grinding
wheels are available as optional accessories.
See page 5 of this manual for more information.
1. Install the unthreaded backing flange (L) on
spindle (M) with the raised section (pilot)
against the wheel.
2. Place wheel (N) against the backing flange,
centering the wheel on the raised section
(pilot) of the backing flange.
3. While depressing the spindle lock button
(C), thread the clamp nut (O) on spindle. If
the wheel you are installing is more than
1/8" thick, place the threaded clamp nut on
the spindle so that the raised section (pilot)
fits into the center of the wheel. If the wheel
you are installing is less than 1/8" thick,
place the threaded clamp nut on the spin-
dle so that the raised section (pilot) is not
against the wheel.
4. While depressing the spindle lock button,
tighten the clamp nut with a wrench (P).
5. To remove the wheel, depress the spindle
lock button and loosen the threaded clamp
nut with a wrench.
NOTE: If the wheel spins after the clamp nut is tightened, check the
orientation of the threaded clamp nut. If a thin wheel is installed with
the pilot on the clamp nut against the wheel, it will spin because the
height of the pilot prevents the clamp nut from holding the wheel.
Mounting Wire Brushes and
Wire Wheels
Wire cup brushes or wire wheels screw directly on the grinder spin-
C dle without the use of flanges. Use only wire brushes or wheels pro-
vided with a 5/8"–11 threaded hub. A Type 27 guard is required
when using wire brushes and wheels.
CAUTION: Wear work gloves when handling wire brushes. Wire
M
brushes can become sharp.
L
MOUNTING WIRE CUP BRUSHES AND WIRE WHEELS
N
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
O
sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
1. Thread the wheel on the spindle by hand.
P
7
1/4" WHEELS
1/8" WHEELS