DeWalt DW402 Manual De Instrucciones página 9

Wire SPINDLE LOCK
Wheels
The spindle lock pin (C) is provided to prevent
the spindle from rotating when installing or
C
removing wheels. Operate the spindle lock pin
only when the tool is turned off and unplugged
Type 27 guard Type 27 guard
from the power supply. Do not engage the spin-
dle lock while the tool is operating because
damage to the tool will result. To engage the
lock, depress the spindle lock button and rotate
the spindle by hand until you are unable to
rotate the spindle further.
4" wire wheel
3" wire cup brush
ACCESSORIES
4 1/2" Cutting Wheels
It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 5-6 for informa-
tion on choosing the correct accessories.
CAUTION: Accessories must be rated for at least the speed
recommended on the tool warning label. Wheels and other acces-
Type 1 guard*
Type 1 guard*
sories running over their rated speed may fly apart and cause
injury. Threaded accessories must have a 5/8"-11 hub. Every
unthreaded accessory must have a 7/8" arbor hole. If it does not, it
may have been designed for a circular saw and should not be used
backing flange
backing flange
for this tool. Use only the accessories shown on pages 5-6 of this
manual. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
Mounting Depressed Center Grinding
Type 1 abrasive diamond cutting wheel
Wheels
cutting wheel
CAUTION: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or acces-
clamp nut
clamp nut sories. Before reconnecting the tool, depress and release the
paddle switch to ensure that the tool is off.
* DW4705 Type 1 Guard (not included) is available at extra cost from your
local retailer.
6