Battery Packs/Batteries - Würth EB 12-A Traducción Del Manual De Instrucciones De Servicio Original

OBJ_BUCH-1120-002.book Page 16 Wednesday, June 8, 2016 2:39 PM
Replace the blade (see figure A)
The upper cutter 10 and the bottom cutter 11 are identical,
have four cutting edges each, and can be exchanged with
each other.
Turn or replace the cutters in good time. Only sharp applica-
tion tools achieve good cutting capacity and make the
machine last longer.
To replace the upper cutter 10, loosen the fastening screw 9;
to replace the bottom cutter 11, loosen the fastening screw
13.
Turn the cutter by 90° or install a new cutter. When installing
the bottom cutter 11, pay attention that it faces against the
adjustment screw 12.
Note: Turn the cutter only in the direction indicated in the
figure and insert a new cutter only in the position shown in the
figure. Cutting is not possible with an incorrectly inserted
cutter.
Retighten the fastening screw 9 for the upper cutter and the
fastening screw 13 for the bottom cutter with a tightening
torque of 3–4 Nm. Check the cutter clearance a (see
"Adjusting Cutter Clearance a", page 15).
Upper cutter 10 and bottom cutter 11 may not be reground.
If the machine should fail despite the care taken in manufac-
turing and testing procedures, repair should be carried out by
a Würth master-Service.
In all correspondence and spare parts orders, please always
include the article number given on the type plate of the
machine.
The current spare parts list for this power tool can be viewed
on the internet at http://www.wuerth.com/partsmanager or
be requested from your next Würth branch office.
Guarantee
For this Würth power tool, we provide a guarantee in accord-
ance with the legal/country-specific regulations from the date
of purchase (verified by invoice or delivery document). Dam-
age that has occurred will be corrected by replacement or
repair.
Damage caused by normal wear, overloading or improper
handling is excluded from the guarantee.
Claims can only be accepted if the power tool is sent undisas-
sembled to a Würth branch office, your Würth sales repre-
sentative or a customer service agent for Würth power tools.
Transport
The contained lithium-ion batteries are subject to the Danger-
ous Goods Legislation requirements. The user can transport
the batteries by road without further requirements.
When being transported by third parties (e.g.: air transport or
forwarding agency), special requirements on packaging and
labelling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is
required.
Dispatch batteries only when the housing is undamaged.
Tape or mask off open contacts and pack up the battery in
such a manner that it cannot move around in the packaging.
Please also observe possibly more detailed national regula-
tions.
Disposal
The machine, rechargeable batteries, accessories and
packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools and batteries/rechargeable
batteries into household waste!
Only for EC countries:
According to the European Guideline
2012/19/EU, power tools that are no
longer usable, and according to the Euro-
pean Guideline 2006/66/EC, defective or
used battery packs/batteries, must be col-
lected separately and disposed of in an
environmentally correct manner.

Battery packs/batteries:

Li-ion:
Please observe the instructions in sec-
tion "Transport", page 16.
Subject to change without notice.
16