Flyback Chronograph - Baume & Mercier Clifton 65717 Manual Del Usuario

SIMPLE CHRONOGRAPH
P1 : Start /stop push-button. Press once to start the chro-
nograph (F=seconds, G =minutes, H=hour). Press a
second time to stop and a third time to start the chro-
nograph again.
P2 : Reset push-button. Once the chronograph has been
stopped by pressing the P1 push-button, press the P2
to reset all counters to zero.
To measure several successive times, without counting
intervals, press the P1 push-button several times con-
secutively, as follows:
1) Start.
2) Stop and read.
3) Start.
4) Stop and read.
This operation may be repeated as often as desired to mea-
sure successive times.
Press the P2 push-button to reset the chronograph to zero.
5)

FLYBACK CHRONOGRAPH

1) Start the chronograph by pressing the push-button P1.
To move directly to the next sequence, press the P2
2)
push-button which will reset the chronograph and
start it immediately for a new measurement.
Note: It is also possible to use the standard Chronograph
function. To do this, refer to the preceding paragraph
CHRONOGRAPH SIMPLE.
12
18 19 20 21 23 24 25 26
20
DUAL TIME FUNCTION CHRONOGRAPH
To use the Chronograph function, refer to the preceding
paragraph CHRONOGRAPH SIMPLE.
Setting the second time zone
1) Set the crown in Position 2.
2) Turn the crown clockwise to advance the second time
zone hand (D) and set it at the desired time.
22