Installation Instructions; Water Tank; Using Ground Coffee - Saeco ARMONIA ESE SS SIL SIN024XN Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
4.2

Installation Instructions

Before installing the machine, read the following safety
instructions carefully.
• Place the machine in a safe place;
• Make sure children cannot play with the machine;
• Do not place the machine on hot surfaces or near open
fl ames.
The coffee machine is now ready to be connected to the
power supply.
4.3
Machine Connection
Electric power may be very dangerous! It is
therefore necessary that the safety regulations
be carefully respected. Do not use faulty power cords!
Faulty cords and plugs must be replaced immediately
in authorized customer service centers.
The voltage of the appliance has been pre-set by the
manufacturer. Check that the voltage matches the
references on the label, at the bottom of the appliance.
• Make sure that the power button (2) is not pressed before
connecting the machine to the power supply.
• (Fig.4A ) - Insert the plug into the socket on the back of
the machine.
• Insert the plug of the other end of the cable into a wall
socket with suitable power voltage.
4.4

Water Tank

• (Fig.1) - Remove the water tank (1). Be careful not to
damage the water suction tube.
• (Fig.2) - Rinse and fi ll it with fresh drinking water, taking
care not to overfi ll it.
• (Fig.3) - Re-insert the tank into its seat and re-position
the water suction tube.
Fill the tank with only fresh, non-sparkling,
drinking water. Hot water or any other liquid
may damage the tank. Do not switch on the machine
with empty tank: Make sure there is enough water in
the tank.
4.5
Priming the Water Circuit
Before starting up the machine, after a long period of
inactivity and whenever the tank is empty, the machine's
water circuit must be primed.
• (Fig.4B) - Press the power button (2). The power light
(3) will turn on.
• (Fig.5) - Place a container under the steam spout.
Open the hot water/steam knob (7) by turning it counter-
clockwise.
• (Fig.6) - Press the brew button (4).
• Wait until a steady jet of water fl ows out of the steam
spout (Pannarello).
• Press the brew button (4) again. Close the hot water/
steam knob (7) by turning it clockwise (Fig.7). Remove
the container.
The machine is now ready to brew coffee and dispense
steam. Please see related sections for operating details.
5
COFFEE BREWING
Warning! Never remove the portafilter by
manually turning it clockwise while coffee is
brewing. Danger of burns.
• During this operation the machine ready light (5) may
fl ash. This should be considered normal.
• Before using the machine, make sure that the hot water/
steam knob (7) is closed and that there is enough water
in the tank.
• (Fig.4B) - If the machine is off, switch it on by means of
the power button (2). The power light (3) will illuminate.
• Wait until the machine ready light (5) comes on. The
machine is now ready to brew coffee.
5.1

Using Ground Coffee

• (Fig. 8A) - Insert the ground coffee fi lter basket (15) into
the portafi lter (14).
• (Fig. 10) - Insert the portafi lter into the brew unit from
the bottom (8).
• (Fig.11) - Turn the portafi lter to the right, until it locks into
place. Release the portafi lter grip. The handle will slightly
turn to the left. This movement ensures the portafi lter's
performance.
• (Fig.13) - Preheat the portafi lter by pressing the brew
button (4) until some water pours out of the portafi lter.
This operation is only necessary for the fi rst coffee.
• After some water has fl owed out, press the brew button
(4) again to stop hot water dispensing.
• (Fig.15) - Remove the portafi lter from the machine by
turning it from right to left and drain any water remaining
in the portafi lter. As the machine is fi tted with the special
portafi lter (14), there is no need to change the fi lter when
making one or two coffees.
• (Fig.8B) - Add 1 or 2 scoops of ground coffee to the fi lter
for one or two coffees, respectively. Clean any coffee
residues from the edge of the portafi lter.
• (Fig.10) - Insert the portafi lter (14) into the brew unit from
the bottom (8).
• (Fig.11) - Turn the portafi lter to the right, until it locks into
place.
• (Fig.12) - Take 1 or 2 preheated cups and place them
under the portafi lter; check that they are correctly placed
under the coffee brewing spouts.
• (Fig. 13) - Press the brew button (4).
• When the desired quantity of coffee has been reached,
• 17 •

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1000276810002403Ri9330/01

Tabla de contenido