Electrical Connection - Sime Estelle B4 INOX Manual Del Usuario

Ocultar thumbs Ver también para Estelle B4 INOX:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
2.5

ELECTRICAL CONNECTION

The boiler is fitted with an electricity
cable, and requires a a single-phase
power supply of 230V - 50Hz through
the main switch protected by fuses.
The room thermostat (required for
KEY
IG
Main switch
TB Tank stat
R
Relay
TL
Limit stat
TS Safety stat
EI
Summer/Winter switch
TC Boiler stat
SPA Water pressure gauge triggered light
SA Power on light
PA Water switch
PI
C.H. pump
38
enhanced room temperature control)
should be installed as shown in fig. 6.
Connect the burner and system circu-
lation pump power cables supplied.
NOTE:
Device must be connected to an effi-
MARRONE - BROWN
NOTE: The brown (capped off) cable has to
be exclusively used in case of permanent
feeding burners (type B1).
PB Tank pump
B
Direct Feeding Burner (not supplied)
B1 Permanent Feeding Burner (not supplied)
TA Room stat
OP Timer programmer
TI
Anti thermal inertia thermostat
NOTE: When connecting the room stat (TA) remove
the bridge between terminals 20-21.
When connecting the Timer Programmer (OP)
remove the bridge between terminals 30-31.
cient earthing system.
SIME declines all responsibility for
injury caused to persons due to fai-
lure to earth the boiler.
Always turn off the power supply
before doing any work on the electri-
cal panel.
Fig. 5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Estelle b5 inox

Tabla de contenido