Preparation For Operation - GRAPHITE 59G323 Instrucciones De Uso

Rectificadora de oscilacion
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
DESCRIPTION OF DRAWING PAGES
Below enumeration refers to the device elements depicted on the drawing pages of this manual.
1.
Switch
2.
Switch lock button
3.
Dust outlet
4.
Dustbag
5.
Sanding paper clamping lever
6.
Sander backing pad
7.
Wheel for oscillation control
8.
Holes for dust extraction
* Slight differences may appear between the product and the drawing
MEANING OF SYMBOLS
CAUTION
WARNING
ASSEMBLY/SETTINGS
INFORMATION
EQUIPMENT AND ACCESSORIES
1.
Dustbag
2.
Sanding paper
CHOOSING SANDING PAPER
Coarse-grained sanding paper is generally used for coarse processing of most materials, while fine-grained
paper is used for finishing works.
When the surface is not flat, start the work with coarse-grained sanding paper and continue until the
surface is flat.
Next use middle-grained paper to remove traces of coarse processing.
To finish the work use fine-grained sanding paper.
INSTALLATION OF SANDING PAPER
Disconnect the power tool from power supply.
Select sanding paper gradation appropriate for the planned task.
To soften the paper, rub its smooth side against an edge, for instance of a tabletop.
Loosen sanding paper clamps (
Fix the sanding paper to the sander backing pad (
Ensure that the holes on the sanding paper (
Bend both ends of the sanding path on the sander backing pad edges.
Tighten sanding paper clamps (
Ensure the sanding paper is installed properly.
Sanding paper must adhere to the sander backing pad. There must be no slack. If the paper stretches
during sanding, remove the slack. It will significantly prolong the lifetime of the sanding paper.
DUST EXTRACTION
Equipment of finishing sander includes dust bag, to maintain the processed surface clean. Use perforated
sanding paper, so the dust can reach extraction hole through the backing pad.
Slide the dust bag (
4) onto dust outlet (3)
Gently pull the dust bag to ensure it is well fixed on the dust outlet.
- 1 pce
- 1 pce

PREPARATION FOR OPERATION

5) (fig. A).
6).
8) and backing pad (6) fully match (fig. B).
5) (fig. C).
11

Publicidad

Tabla de contenido
loading

Tabla de contenido