Tabla de contenido
Publicidad
ESPECIFICACIONES DE INSTALACIÓN (continuación)
ELECTRÓNICA DE SENSORES
1. Bolsillo de la Electrónica del Sensor
Mecanizar un bolsillo para almacenar
•
componentes electrónicos del sensor de
1.81" (46, 0 mm [
, 0.815 "(21 mm [
y 0.466 "(12 mm [
profundo.
Los bolsillos electrónicos también pueden
•
estar centralizados dentro delabrazadera
o placas de expulsión, como se muestra
a la derecha; hacer referencia a las
dimensiones especificadas anteriormente
por sensor/electronics paquete.
1.81" (46, 0 mm)
1
0.815" (21 mm)
2
0.466 " (12 mm) no mostrado
Lynx™ Embedded Sensors (LES-B-127-XXX) Installation—Sensor Electronics Alternate Installation
3
XXX = ±0.003 [0.08]
XX = ±0.01 [0.3]
ANGLES = ±3° 30°
Manual del Producto | Sensores Integrados Lynx ™ LES‑B‑127‑50/125/500/2000
a la derecha]) enlargo
1
a la derecha]) enancho
2
no mostrado])
3
Sensor electronics can be grouped and installed in a single pocket within the mold, as shown below.
Refer to pages LES-B-127-XXXX-06 and LES-B-127-XXXX-09 for all sensor electronic pocket dimensions.
Drawing Title: LES-B-127-XXXX-10
1
NOTES:
1.
EJECTOR PIN AND SENSOR CONCENTRICITY MUST BE WITHIN
0.030" [0.76] OR 10% OF EJECTOR PIN DIA, WHICHEVER IS
SMALLER.
2.
DO NOT SCALE PRINT
3.
BREAK ALL SHARP EDGES, 0.005 [0.03] R MAX
4.
DIMENSIONS IN INCHES [MM], UNLESS NOTED
5.
TOLERANCES UNLESS SPECIFIED:
XXX = ±0.003 [0.08]
XX = ±0.01 [0.3]
ANGLES = ±3° 30°
Lynx™ Embedded Sensors (LES-B-127-XXX) Insta
Sensor electronics can be grouped and installed in a
Refer to pages LES-B-127-XXXX-06 and LES-B-127-XX
2
Description: LES-B-12
RJG, Inc.
Sensor Installation
3111 Park Drive
Drawn: K.J.Brettschne
231-947-3111
Design:
www.rjginc.com
Check: M. Groleau
Date: 03.03.2021
27
Publicidad
Tabla de contenido
