Tabla de contenido

Publicidad

1. Engine oil filler cap
1. Bouchon de remplissage d'huile de moteur
1. Tapa de relleno de aceite de motor
1. Maximum level mark
1. Repère de niveau maximum
1. Marca de nivel máximo
2. Minimum level mark
2. Repère de niveau minimum
2. Marca de nivel mínimo

Engine oil

Engine oil level measurement
1. Remove panel F. (See page 8-29 for panel
removal and installation procedures.)
2. Place the ATV on a level surface and warm
up the engine for several minutes.
3. Stop the engine.
4. Remove the engine oil filler cap and wipe off
the dipstick with a clean rag.
5. Insert the dipstick in the filler hole without
screwing it in.
NOTE:
_
Wait a few minutes until the oil level settles before
checking.
_
6. The oil level should be between the maxi-
mum and minimum marks. If the level is low,
fill the engine with sufficient oil to reach the
specified level.
8-31
EBU01099

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Yfm450far

Tabla de contenido