Integra Pro DLX UltraLite 003285NTSC Instrucciones De Uso página 9

Infrequently, you will need to use the RCA plug to connect to a monitor or recording device. In order to do this,
connect the RCA plug adapter to the end of the BNC cable as shown below.
Step 2: Camera head connection to the CCU:
CAUTION:
Carefully align the slot on the camera head
connector with the keyway shown on the front
of the CCU. See Figure 4.
Step 3: Power ON.
1. Connect power cord to rear of CCU.
2. Plug the CCU power supply to the wall outlet. (Do not turn on Camera yet).
3. Plug and turn on the monitor, recording device and/or printer.
4. Select Line A or Line B.
5. Put on the headlight with the camera.
6. Connect the headlight cable to a compatible light source.
7. Turn on the light source and the camera power. The camera power switch is located on the front panel of the CCU.
8. Look at the front of the monitor. A picture should be visible on the monitor.
CAUTION: The camera head MUST be connected to the CCU PRIOR to turning on the CCU.
Connecting the camera head to the CCU while the power is on will damage or destroy the video chip.
If you still do not have a picture, make sure you have selected the same Line A or B that you have selected in the rear of the monitor.
If you still do not have a picture, turn OFF the camera power and check all of your connections on the camera, recording device,
printer, and monitor. Turn the camera power back on. If you still do not have a picture, please contact your local Integra sales
representative.
Figure 4
7