Menu Settings - HSM Powerline HDS 150 Manual De Instrucciones

Shredding material
• Add the data carrier to the infeed slot (1).
2
Pulling the slide (2) will allow the material
to be discharged into the cutting unit.
Do not add new material until the hand symbol
disappears and the LED on the operator control
panel lights up green.
Ending material shredding
• Press the Stop button.
Switching the hard drive shredder off
• Turn the main switch to the
position 0.
In this position you can secure the
main switch against unauthorised
switch-on using a padlock.
05/2016
1
  The cutting unit
shreds the data carrier.
The shredding is shown
schematically using
several pictures on
the display panel.
6

Menu settings

The structure of the menu is described in detail
on the next page.
The arrows on the display panel will show you
which control buttons are active and which func-
tions you can select with them.
Powerline HDS 150
After pressing the menu button you
can adjust settings and query stored
values. By pressing the button again
you will exit the menu.
Confi rm the selected values using
the Enter button.
Use the control button to navigate
within the menu.
Select material

Hard drive
 
next | previous
english

21