Publicidad
Step 16
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw
Fasten a GLASS DOOR (J) to the RIGHT UPRIGHT (D).
å
Use the screws in the HINGES.
Fasten a DOOR MOLDING (T) to GLASS DOOR (J). Use
å
two BROWN 1" FLAT HEAD SCREWS (12S).
Fasten a KNOB (28K) to the GLASS DOOR (J). Use a
å
SILVER 1-1/2" MACHINE SCREW (95S).
Repeat this step fastening the other GLASS DOOR (J) to
å
the LEFT UPRIGHT (E).
See the next step for DOOR adjustments.
å
Page 20
Stop
Mounting
screw
D
E
SILVER 1-1/2" MACHINE SCREW
(2 used in this step)
420408
Hinge
BROWN 1" FLAT HEAD SCREW
(4 used in this step)
J
T
95S
www.sauder.com/services
12S
28K
Publicidad
