Automatic Operation (Auto Changeover) - Toshiba RAV-SM402MUT-E Manual Del Propietário

6
AUTOMATIC OPERATION
(Auto Changeover)
When you set the air conditioner in
it will automatically select either cooling, heating, or fan only operation depending on the indoor temperature.
3
Start
1
ON / OFF
button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select Auto.
3
Temperature button
Set the desired temperature.
• In case of cooling, start the operation after approx. 1 minute.
• In case of heating, the operation mode is selected in accordance with the room temperature and operation
starts after approximately 3 to 5 minutes.
• When you select the Auto mode, it is unnecessary to set the fan speed.
The FAN speed display will show AUTO
• After the heating operation has stopped, FAN operation may continue for approx. 30 seconds.
• When the room temperature reaches the set temperature and the outdoor unit stops, the super low wind is
discharged and the air volume decreases excessively.
• If the Auto mode is uncomfortable, you can select the desired conditions manually.
NOTE
When restarting the operation after stop
• When restarting the operation immediately after stop, the air conditioner does not operate for approx. 3 minutes
to protect the machine.
Stop
ON / OFF
Push button.
Push this button again to stop the air conditioner.
All manuals and user guides at all-guides.com
mode or switch over from AUTO operation because of some settings change,
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL SWING/FIX
and the fan speed will be automatically controlled.
8
ON / OFF
FAN MODE
SAVE VENT
UNIT LOUVER
1
2
English-8