Installation Instructions - Jacuzzi ERA Instrucciones Para La Instalación Y El Funcionamiento

ERA™ Riser Tubes and T-Bracket
Installation Instructions - Freestanding Supply Lines

Installation instructions:

Before drilling holes in the floor, please determine the with of the faucet and where the supply lines attach. Now
determine
where your tub lip will be to make sure faucet spout is 1" inside the tub lip.
1. Drill two 1 1/8" holes as per your determined measurements.
2. Slide escutcheons up from the bottom of each riser tube and install one 3/4" brass flange nut on each riser.
3. Lower riser tubes through the floor (make sure you have valve handles facing out from each other). Install other 3/4"
brass flange nuts (leave loose and attach faucet). Then tighten flange nuts, securing riser tubes to the floor.
4a. If you are using plastic water lines, a 3/4" FIP barb adapter will attach directly to the 3/4" thread on the riser tube.
4b. If you are using copper pipe, you will have to use the 3/4" & 1/2" brass reducers and the 3/4" fiber washers (make
sure to soak the washers in water before using). Put washer between riser tube and reducer and tighten using allen
wrench. Attach to your copper line.
Installation Instructions - Support Rods
Installation instructions:
1. Slide loop brackets over supply lines and measure the distance between the two.
2. Assemble T- bracket with two of the rods and the center connector. Cut as needed to the desired length.
3. Attach rods to the supply line loops with set screws. Some adjustments may be needed.
4. Slide loop bracket over waste line and measure the distance to the T-bracket center connector.
5. Thread rod into center connector Cut as needed to the desired length.
6. Attach rod to the waste line loops with set screw. Some adjustments may be needed.
Installation Instructions - Faucet to Supply Lines
Installation instructions:
1. Thread hex nuts on the back of the faucet to the riser tubes. Do not use S-unions for attaching to supply lines.
2. Make sure faucet is level and tighten until it is secure.
3. Once installed, remove aerator and hand shower to flush faucet and water lines. This will remove any debris that
may be trapped. Then attach shower head and aerator.
Installation Instructions Page 5