Undermount Installation Instructions - Jacuzzi BUILDER Serie Manual De Instalación Y Operación

UNDERMOUNT INSTALLATION INSTRUCTIONS

Installation
A typical installation will have these construction char-
acteristics.
Unit Protection
If protective film has been removed, reapply film. For added protection, place a drop cloth or other material in the bottom
of bath for protection. Be careful not to scratch the bath surface.
Counter Preparation
NOTE: On pump/motor side of bath, the counter should extend a minimum of 4" past the outer edge of bath, in order
to clear the pump/motor plumbing extending beyond the rim of the bath.
Position the template so that the cutout oval aligns with
the rim edge.
TEMPLATE
BATH RIM
In this position, using a grease pencil, mark on the bath
the center line positions through the cut out slots. Re-
move template. Measure from marked center lines to a
fixed point such as a wall.
Transfer these measurements to counter and mark center lines positions. Position template and cut counter for the
desired offset.
A
TEMPLATE
COUNTER
After cutting is complete, perform any needed routing, edge work or polishing to the counter.
*MORTAR MUST BE IN CONTACT WITH ALL FOAM FEET
INSIDE EDGE
COUNTER
OF RIM
B
C
D
17
COUNTER
MORTAR*
MOTOR/PUMP
A
MEASURE FROM
CENTERLINE
MARKS TO WALL
COUNTER
BATH RIM
OFFSET
Jacuzzi Whirlpool Bath© K272000AC 12/04
STUD WALL
B
C
D
COUNTER
BATH RIM