Please read and follow these instructions before using the equipment!
•
Keep the operating and maintenance manual in a safe place.
•
If the device is used contrary to the procedure described in chapter Safety
instructions and chapter Intended use, the protection supported by the device may
be impaired.
•
The equipment is designed for indoor use only.
•
The equipment including its original packaging must not be exposed to weather.
This applies during operation and for transport.
•
Use the equipment only for the extraction of dust and smoke!
•
Do not use the equipment for the extraction of burning or glowing matter!
•
For extraction with spark-generating processes, use an effective spark extinguisher
or spark arrestor. (i.e.: TBH ATEX spark extinguisher or FA10, FA20)
•
Do not use the equipment for extracting highly flammable or explosive gases.
•
Do not use the equipment for extracting aggressive substances, explosive dusts
and aluminium grinding dust.
•
Do not use the equipment for the extraction of any type of liquids. (Exception:
Equipment of the OEN series, see Intended Use)
•
When liquids or foam leak out, the equipment must be switched off immediately and
disconnected from mains. (Only for equipment of the OEN series)
•
Regularly check the liquids collection tank and the filling-level monitoring device.
(Only for equipment of the OEN series)
•
Protect the power cable from heat, moisture, oil and sharp edges.
•
The device should be set up so that it is not difficult to operate the separating device.
•
Observe the permissible supply voltage (see note on the type plate).
•
Use only original spare parts.
•
Use only original spare filters.
•
Do not operate the equipment without filter.
•
Even a single missing filter or filter equipment can also lead to a loss of filtration
performance.
•
Before opening the equipment or carrying out maintenance or cleaning work,
disconnect the mains plug!
•
The outlet opening may not be covered off or blocked.
•
Any cooling-air intakes and outlets may not be covered off or blocked.
•
Always make sure that the equipment stands securely.
•
Use only the provided TBH crane eyelets! Make sure to observe the enclosed brief
instructions.
•
In case of technical problems, please contact the manufacturer or your specialist
dealer!
•
When extracting carcinogenic, harmful or environmentally hazardous substances,
the national regulations for health and safety at work must be observed (in Germany
for example: TRGS 560)
•
When extracting welding or laser smoke from nickel- or chrome-containing
materials and other carcinogenic metals, the national regulations for health and
safety at work must be observed (in Germany for example: TRGS 528).
Personal Safety Equipment
For all types of work on used filters, filter housings, pipes, hoses, extraction elements
and other parts that come into contact with the extracted media:
•
Observe local factory regulations!
•
Respiratory protection: Half mask according to FFP-3 compliant with
(unless otherwise specified)
•
Rubber gloves
Safety Instructions
61
EN149