Centrometal SLIM 6 Manual Del Usuario página 38

Function chrono-thermostat
(available only through the remote control)
With the function chrono-thermostat, you can
schedule up to two automatic switching on and off
of the stove per day.
If you want to repeat the switching on and off every
day, then you need to use the function AUTO too (as
explained in the paragraph "Daily repeat AUTO").
• The time of the automatic
switching on and off must be set
when the remote control is Off;
• In the event of an even very short lack of
current, you will miss the set time for the
automatic switching on or off. Once the
power supply is back, please program
the stove again using the remote control;
• The stove switching on at the scheduled
time will keep the same temperature and
power you set before you last switched
it off;
• Please consider an interval of min. 20
minutes between the switching off and
subsequent switching on of the stove.
In this way the unit will have time to
arrange a complete cooling phase; in
the event this minimal interval is not
calculated, the stove will not switch on
as scheduled.
Program 1 (ON1
OFF1)
Automatic switching on
ON1
Please join the following
procedure to set the time for
the automatic switching on
according to the program 1:
(1). You
Press the key
will see the hours and
minutes and the symbol
ON1 blinking on the remote
control. Use the keys
and (3) to change the
wished time (intervals of 10
minutes). To scroll the time
faster, keep the keys
and (3) pressed.
Confi rm your selection
pressing the key
once again.
You will now read the set switching on time on
the remote control. Press SEND (4) to transmit your
selection to the pcb of the stove.
The LED chrono-thermostat will light up on the
control board indicating that the programming is
on (5).
10
and
(2)
(2)
(1)
AL C AL F
Automatic switching off
OFF1
Press the key
will see the hours and
minutes and the symbol
OFF1 blinking on the remote
control. Use the keys
and (3) to change the
wished time (intervals of 10
minutes). To scroll the time
faster, keep the keys
and (3) pressed.
Confi rm your
pressing the key
once again.
You will now read the set
switching off time on the
remote control. Press SEND
(4) to transmit your selection to the pcb of the
stove.
The LED chrono-thermostat will light up on the
control board indicating that the programming is
on (5).
The LED chronothermostat switches off as soon as
the automatic switching on and off are completed.
The remote control does not show the previously
set time schedule anymore.
Program 2 (ON2 and
OFF2)
As above but with the
keys ON2 and OFF2
Cancel any
already set timetables.
Please join the following
procedure to cancel any
other already set timetables.
This example refers to the
4 automatic switching off of
2 the program 1 (Off1). The
procedure is the same for
3
all plans.
Press the key corresponding
to the switching on or off time you want to cancel.
1
Referring to the example: press the key
You will see the hours and minutes and the symbol
OFF1 blinking on the display of the remote control.
Now press the key "CANCEL" (2) to cancel the
automatic switching on or off timetables from the
display.
Press the key SEND (3) to confi rm your selection
and transmit it to the pcb of the stove.
5
(1). You
(2)
(2)
selection
(1).
eventual
4
2
3
1
3
1
2
(1).