Display Information - Centrometal SLIM 6 Manual Del Usuario

Daily repeat AUTO
Using the function AUTO,
you can repeat the single
automatic switching on and
off you selected every day.
You just need to press the
key AUTO (1) for at least
two seconds to activate
the function. You will read
the words AUTO (2) on
the display of the remote
control. Press SEND (3) to
confi rm your selection and
transmit it to the pcb of the
stove.
The LED chrono-thermostat
will light up on the control board indicating that
the programming is on.
You can deactivate the automatic repeat whenever
you want just pressing the key AUTO again for at
least two seconds. The words AUTO will disappear
from the display. Press SEND (3) to confi rm your
selection and transmit it to the pcb of the stove.

Display information

"OFF": the stove is off or it is in a
shutting down phase.
"FAN-ACC": the stove is in the
phase of preheating the resistor,
preceding lighting.
"LOAD WOOD": the stove is
loading pellets. On the control board
the LED resistance is on.
"FIRE ON": The stove is in the fl ame
stabilization phase (fl ame present).
"ON 1": the stove is in the operational
phase at minimum power.
Air distribution frontal-canalization (if any)
It is possible to manually adjust the distribution of
air between frontal and ducted.
To adjust the outgoing air, it will be necessary to
move the lever from the bottom to the top.
The more the lever is moved upwards, the more the
air is directed to the front of the stove.
The manual setting will act on the gate valve of air
distribution. The air will be then directed through
the canalizations.
Always clean the brazier before
2
starting an automatic switching on
in order to avoid any possible missed
starts up which would damage your
stove and the environment.
3
Replace the batteries of the remote control
If you need to replace
the batteries of the
1
remote control, remove
the back cover as shown
in the picture. Replace
the old batteries with
the new ones respecting
the polarity + and -.
The batteries needed
are AAA, 1,5 V.
"ECO": the stove has reached the
temperature set by the user and is
in the energy saving phase. In this
phase it is not possible to modify the
power setting.
If the temperature is set at 41°C
the stove will remain in continuous
operation
work power without passing to the
economy mode (ECO).
"STOP FIRE": the stove is in a
self-cleaning of the basket phase;
the smoke extractor runs at the
maximum speed and the pellet
loader at minimum.
"ATTE": you will read these letters
when you try to start up the stove
while it is completing a cooling
cycle. Wait until the cooling phase is
completed before proceeding with a
new switching on.
at the programmed
11