Centrometal SLIM 6 Manual Del Usuario página 48

11 11
12 12
Control twice a year
(beginning and middle of the season)
Glass cleaning of the "T" joint
1 1
2 2
20
Then remove the slide
of the pellets entering.
(photo 11)
Remove the wall of the
combustion chamber
and of the smoke flue.
(photo 12)
The stove body is now
fully accessible for an
accurate cleaning. (photo
13)
13 13
Remove the three screws
behind the top and lift it.
(photo 1)
Then remove
supporting screws
the side from inside the
stove and remove the
side. (photo 2)
Rotate the ash tray. Clean
up the ash tray glass from
the waste accumulated
during operation of the
stove. (photo 3)
3 3
Cleaning the clearing system
Until a reasonable experience is acquired regarding
the operating conditions, it is advisable to perform
this maintenance on at least a monthly basis.
• remove the electrical feed cable;
• remove the cap from the T-joint and proceed
with the cleaning of the ducts. If necessary, at least
for the first few times, call in qualified personnel;
• carefully clean the smoke discharge system: for
this, contact a professional chimney sweep;
• once a year clean the dust, cobwebs, etc. from
the zone behind the internal covering panels,
paying particular attention to the fans.
Cleaning the fans
The stove is furnished with fans (environmental
and smoke) positioned at the rear and below the
stove.
Eventual deposits of dust or ash on the blades of
the fan can cause an imbalance in the fans leading
to noisy performance. It is, therefore, necessary to
clean the fans at least once a year.
Since said operation requires dismantling several
parts of the stove, have the fans cleaned only by
our Technical Assistance Centre.
Season end cleaning
At the end of the season, when the stove will not
be used for some time, it is advisable to perform a
thorough and general cleaning:
• Remove all the pellets from the container and
the screw feeder;
the
of • Carefully clean the brazier, the brazier support,
the combustion chamber and the ash box.
Once the preceding points have been observed,
it only means that the state of the stove has
been verified. It is necessary to thoroughly clean
the smoke discharge tube or flue and check the
condition of the basket. If necessary, order a new
one from our Authorized Assistance Centre. If
necessary, lubricate the hinges of the door and the
handle. Also check the ceramic fibre cord near the
glass, on the internal wall of the door; if it is worn
or too dry, order a new one from the Authorized
Assistance Centre.