Klarstein VAN HELSING Manual De Instrucciones página 13

ASSEMBLY
1. Using the bolts, nuts and washers provided, attach the
motor bracket to the left side of the grill (or right side
depends on your grill) as shown in Fig 1 by inserting a
bolt through the bracket and then through the outside
of your grill. Place a washer on the end of each bolt.
Secure bolts with nuts. Do not over-tighten the bolts.
Attach the spit rod bracket to the other side of your
grills by similar step as stated above (depends on your
grill).
2. The bracket is adjustable in many ways. Check to see
if the adjustable bracket fits your grill. If not, there
are two methods to reassemble the bracket:
a) Use Phillips screwdriver and plier (not provided) to
loosen the screws on Part Z (Fig 2-1). Decide where
you want to mount the motor. Move Part Z to the
proper hole and tighten the screws (Fig 2-1~2-3).
b) If the adjustment of bracket as per above step (a)
still doesn't fit your grill, loosen the 3 screws that
hold together Part X & Y (Fig 3-1). Turn Part X upside
down and reassemble it to Part Y, making the whole
mit Zange
festhalten
EN
13