sunjoe SPX3200 El Manual Del Propietario página 10

Fig. 12
ON/OFF switch
(pressure select dial)
NOTE: This unit is equipped with pressure select
technology. The low setting provides 870 PSI rated
pressure, and the high setting provides 1450 PSI rated
pressure.
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40˚ (for gentle cleaning), 25˚
(for all-purpose cleaning), 15˚ (for tough jobs), 0˚ (for spot
cleaning or hard-to-reach areas) and the Soap nozzle
(for detergent application).
m
CAUTION!
NEVER change nozzles without locking the
safety lock on the trigger handle.
m
WARNING!
High-pressure jets can be dangerous if
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with five (5)
Quick-Connect nozzles that easily snap onto the
Quick-Connect collar of the spray wand.
To connect a nozzle to the spray wand:
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 13).
Fig. 13
3. Snap the desired nozzle onto the Quick-Connect collar
until it clicks into place (Fig. 14).
Fig. 14 Spray wand quick-
connect collar
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
4. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
5. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 13).
6. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
m
WARNING!
Do not make changes to the nozzle while
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
10
Slot
Safety lock
Nozzle
"Click"