4. Connect the high-pressure hose to the trigger gun (Fig. 4).
Fig. 4
High-pressure hose
5. Connect the other end of high-pressure hose to the water
outlet on the washer (Fig. 5).
Fig. 5
High-pressure
hose
High-pressure
water outlet
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
6. Connect the garden hose adapter (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adapter
(Fig. 6). The garden hose must have an internal
diameter of at least 13 mm (1/2 in.) and must be
reinforced. The water supply must be at least equal to the
washer delivery capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
Fig. 6
Garden hose
(male end)
Trigger gun
Garden hose
7. Attach garden hose to water supply (Fig. 7).
Fig. 7
Connect to water supply
m
WARNING!
m
WARNING!
system, the system shall be protected against backflow.
m
WARNING!
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
m
CAUTION!
do not allow it to operate dry. Before starting the appliance,
make sure that it has proper and stable supply of water.
8
This end to
water inlet
Garden hose
Do not connect to potable water system.
If connection is made to a potable water
The intake water temperature must not
The washer must only be used with clean
To prevent damage to the appliance,