Troubleshooting - ARIETE Moka aroma 1337 Manual De Instrucciones

Ariete's NOCAL, citric acid-based decalcifying products. This product is easily found at the Ariete technical
service centres. Ariete does not assume any responsibility whatsoever for damage to components inside the
coffee machine caused by the use of non-compliant products containing chemical additives. Should you need
to decalcify your appliance, please follow the instructions which come with the decalcifying product.
puTTIng ouT oF serVIce
If the machine is put out of service, electrically disconnect it. Empty the water tank. Use the handle to tilt the
appliance and make the water come out of the spout while paying close attention that the water does not
dampen the switch area to prevent infiltrations inside electrical parts. Empty the drip tray and clean it (see
paragraph "Cleaning the appliance").

TroubleshooTIng

Warning!
If there are problems with operation, immediately turn off the machine and unplug it from the socket-outlet.
PROBLEMS
The coffee maker
does not supply
boiling water for
tisanes.
Steam overflowing
from the edges of the
filter ring.
The coffee maker
does not supply
steam.
Coffee overflowing
from the edges of the
filter ring.
CAUSES
Air has probably entered the
circuit and deactivated the
pump.
The steam exit hole on the
dispenser wand is clogged
You are trying to dispense
the coffee with the steam
function on. Check that the
steam function button has not
been unintentionally pressed.
There is little water and the
pump does not suck it up.
The steam exit hole on the
dispenser wand is clogged.
Probably an excess amount
of ground coffee has been
placed in the filter ring
preventing the filter ring from
being correctly tightened into
its housing.
Residues of ground coffee
have remained on the gasket
of the filter holder coupling
seat.
The hole of the silicone disc
is clogged.
The exit holes of the filter
containing coffee grounds are
clogged.
Faulty pod.
SOLUTIONS
Check that the water level in the tank is correct.
If necessary, fill it with cool tap water. Repeat the
operations described in the "Preliminary phases for
use" paragraph.
Unclog any deposits that may have formed in the
hole of the dispenser wand with a pin.
Stop the coffee delivery. Press the button (T) to cut
out the steam function. Wait for the lamp (S) to turn
on before making another cup of coffee.
Check that the water level in the tank is correct. If
necessary, fill it with cool tap water.
Unclog any deposits that may have formed in the
hole of the dispenser wand with a pin.
Slowly remove and disconnect the filter holder
because any remaining pressure could cause
splashes or squirts. Clean the coupling seat with a
sponge (Fig. 12). Repeat the operation placing the
correct quantity of coffee in the filter.
Clean the seal with a toothpick or a sponge (Fig.
12).
Wash the silicone disc (I) under running water,
bending it slightly on the sides in order to free the
centre hole of any residue of coffee grounds that
could clog it (Fig. 11).
Slowly remove and disconnect the filter holder
because any remaining pressure could cause
splashes or squirts. Clean the clogged filter
holes with a small brush or a pin. Clean the filter
using Ariete COFFEE CLEAN tabs, following the
instructions provided in the package.
Replace the pod in the filter holder (U).
19