Kit Preparation; Kit Assembly - Metra 95-6555B Instrucciones De Instalación

KIT PREPARATION

Attention! The factory dashboard trim panel
and sub-dash will have to be cut to allow the
aftermarket radio to fit. Once cut, the factory
radio and ashtray will no longer be able to
be re-installed.
1. Unscrew the cigarette lighter from
the factory dashboard panel.
2. Temporarily clip the panel back to
the vehicle.
3. Place the cut template over the panel,
then secure using the ashtray assembly
hardware. Mark the area to be cut.
(Figure A)
4. Remove the screws securing the cut
template, then discard. Remove the
panel from the vehicle.
5. Cut the areas shown from the panel
and sub-dash to allow room for the
aftermarket radio. (Figure B, C)
6. Install the cigarette lighter to the radio
trim panel.
Continue to Kit Assembly
(Figure A)
Remove shaded area
(Figure B)
Remove shaded area
(Figure C)

KIT ASSEMBLY

1. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Slide the radio assembly into the dash,
then secure using the factory hardware.
4. Reconnect all factory harnesses to the
dashboard trim panel. Clip the panel
back to the dash.
5. Reinstall the cup-holder assembly using
the factory hardware.
6. Reconnect the cigarette lighter harness.
Snap the radio trim panel onto the
dashboard trim panel, then secure
using the (2) screws provided. Snap the
screw cover over the left screw cavity to
complete the installation. (Figure B
(Figure A)
(Figure B)
)
REV. 1/6/2020 INST95-6555B
3