Emptying The Dust Cup - Uline SHARK NAVIGATOR LIFT-AWAY H-8831 Manual Del Usuario

ABOVE-FLOOR EXTENDED REACH
Follow instructions for
detaching the pod
above. Press the wand
release button to remove
the wand from the pod.
Attach an accessory
to the end of the wand.
(See Figure 7)
ABOVE-FLOOR
Follow instructions for
detaching the pod and
wand. Press the handle
release button to detach
the handle from wand.
Attach an accessory to
the end of handle.
(See Figure 8)
NOTE: All
accessories are
compatible with
both the wand
and the handle.

EMPTYING THE DUST CUP

IMPORTANT! Unplug the power cord before
performing any maintenance.
1. Undo the latches
on the sides of
the dust cup by
lifting them up and
out. Tilt the dust
cup and lift it off
vacuum pod.
(See Figure 9)
PAGE 4 OF 21
OPERATION CONTINUED
Figure 7
Figure 8
Figure 9
2. To empty debris
into trash, press
lower release
button and
bottom of dust
cup will drop
open.
(See Figure 10)
3. To remove
collected debris
from lint screen,
press top release
button and lift
handle to open.
Gently brush lint
screen to clean.
(See Figure 11)
4. To reinstall, set bottom
of dust cup on pod
and tilt until dust cup
clicks into place.
(See Figure 12)
Figure 10
Figure 11
Figure 12
0820 IH-8831