HIKOKI VTP-18 Instrucciones De Manejo página 4

English
RECAUTIONS ON USING IMPACT DRILL
1. Before drilling into a wall, floor or ceiling, thoroughly
confirm that no items such as electric cables or
conduits are buried inside.
SPECIFICATIONS
Model
Voltage (by areas)*
Power input
Speed change
No-load speed
Capacity: Steel
Concrete
Weight (w/o cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Chuck Wrench ........................................................... 1
(2) Side Handle ............................................................... 1
(3) Depth Stopper .......................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Drill Bit for concrete
O.D. Length
6.5 mm 100 mm
8.0 100
9.5 120
10.0 120
12.0 160
13.0 160
14.3 160
16.0 160
18.0 300
Optional accessories are subject to change without notice.
APPLICATIONS
By combined action of ROTATION and IMPACT:
Boring, holes in concrete, marble, granite, tile and
similar materials.
By ROTATION only:
Boring holes in metals, wood and plastics.
4
2. Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
VTP-18
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
1 2
1050 /min 1800 /min
13 mm 8 mm
18 mm 10 mm
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
serious injury.
3. Extension cord
Code No.
When the work area is not near a power source.
Use an extension cord of sufficient thickness and
931851
rated capacity. The extension cord should be kept
931852
as short as possible.
931853
4. Fitting the Drill Bit
Fit the drill bit into the chuck and use the chuck
931854
wrench to secure it, tightening the chuck by each
971704
of the three holes in turn.
5. Selecting the appropriate drill bit
931855
When boring concrete or stone:
931776
Use the drill bits specified in the Optional
971670
Accessories.
When boring metal or plastic:
950496
Use an ordinary metalworking drill bit.
When boring wood:
Use an ordinary woodworking drill bit. However,
when drilling. 6.5mm or smaller holes, use a
metalworking drill bit.
6. High-speed/Low-speed changeover
Prior to changing speed, ensure that the switch is
in the OFF position, and the drill has come to a
complete stop. To change speed, depress the shift
lock and slide it in the appropriate direction, as
indicated by the arrow in Fig. 1. The numeral "1"
engraved in the drill body denotes low speed, the
numeral "2" denotes high speed.
VTV-18
640 W*
1
0 – 1050 /min
13 mm
18 mm
2.3 kg
2
0 – 1800 /min
8 mm
10 mm