Publicidad
Idiomas disponibles
Idiomas disponibles
AB23PH Bench pH Meter
Controls
Button
Exit
Store
Recall
pH/mV
Read/Enter
Auto - Stop
Buffer
Temp.
Cal
Cal.Data
Figure 1-2 Control Panel
Press & release
Turns on the meter
Cancels the current measurement
Exits calibration
Stores the current measurement result
When checking the stored
measurement results, moves to the
previous record.
When setting parameters, increases
the setting value or displays the
previous option.
Switches between pH and mV mode.
Starts or ends measurement
Ends the current measurement in the
auto endpoint mode and shows the
result
Confirms settings and stores setting
parameters
Selects buffer group
When checking the stored
measurement results, moves to the
next record.
When setting parameters, decreases
the setting value or displays the next
option.
Starts calibration
EN-5
Press & hold
for 3 seconds
Turns off the meter
Recalls stored
measurement results
/
Switches between
auto and continuous
endpoint mode
Auto
Continuous
Enters temperature
setting, selects
temperature unit and
sets MTC
temperature (The
default is 25.0 C°
degrees)
Recalls the latest
calibration data:
slope and offset
Publicidad
Capítulos
