Cleaning The Tool - Makita DUN461W Manual De Instrucciones

To cut a hedge side evenly, cut from the bottom to top.
15 m
When trimming to make a round shape (trimming boxwood or rho-
dodendron, etc.), trim from the root to the top for a beautiful finish.
15 m
If the chip receiver is attached to the shear blades, it gathers
discarded leaves and makes clean-up afterward much easier.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
CAUTION:
When inspecting or maintaining the
tool, always put the tool down. Assembling or adjusting
the tool in an upright position may result in serious injury.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the tool

Clean the tool by wiping off dust with a dry cloth or one
dipped in soapy water and wrung out.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
Shear blade maintenance
Before the operation or once per hour during operation,
apply low-viscosity oil (machine oil, or spray-type lubri-
cating oil) to the shear blades.
After operation, remove dust from both sides of the
shear blades with a wired brush, wipe it off with a cloth
and then apply low-viscosity oil (machine oil, or spray-
type lubricating oil) to the shear blades.
15 m
NOTICE:
Doing so may cause rust or damage to the tool.
NOTICE:
blade friction and shorten the operating time per
battery charge.
Storage
Attach the blade cover to the shear blades so that the
blades are not exposed. Store the tool out of the reach
of children. Store the tool in a place not exposed to
moisture or rain.
13 ENGLISH
Never use gasoline, benzine, thinner,
Do not wash the shear blades in water.
Dirt and corrosion cause excessive