Steelcase Elective Elements - Leg Base Credenza Shipped Assembled Manual De Instrucciones página 4

3.
Attach front legs using (7)
#10 x 1.075" screws each leg,
in predrilled holes.
4.
Attach reveals using 8-32 x
.375" tri-lobe screws and washers,
making sure they are flush to legs.
NOTE: In a back-to-back condition with
another storage unit, to minimize the gap
between legs: DO NOT use predrilled holes
to locate legs. Install rear legs first, by
aligning them flush to the rear of the unit
and inset .062" (1/16") from the side of the
unit. Then install reveal and use it to locate
front legs.
Tip: adjust each glide
to an equal height (start
with approximately 1/4"
of extension).
Position reveal
flush with leg.
Use the SHADED ( ) holes for attachment.
STANDARD
OFFSET (for Shared)
REAR
Tip: Make sure that the
torque control drill is set
properly to prevent stripping
of screws.
FRONT
4
REVEALS
STANDARD
STANDARD
OFFSET
3
FRONT LEGS
Page 4 of 24
939568000 Rev D