Complete Installation - Steelcase Elective Elements - Leg Base Credenza Shipped Assembled Manual De Instrucciones

Complete Installation

1.
Reinstall all drawers, doors, and
shelves where applicable.
Confirm that the locks and
interlocks function properly.
2.
Check to see if units are level.
3.
Slide glide cover up and use wrench
to adjust glide.
4.
After glide is adjusted slide glide
cover back down.
TIP: Glide adjustment
may be necessary to
improve headset
alignment.
3
NOTE: Glide adjustment tool is available through
Steelcase Service Parts (part number Y565727SR)
4
NOTICE
Steps for correct installation of
soft close drawers
2
1 Pull LH and RH suspensions to full extents
2 Find and disengage rear posts, LH and RH
3 Align drawer suspensions and install
1
2
Soft close mechanism
can be damaged if this
step is skipped.
3
RH post is
shown here
in yellow
1
939568000 Rev D
Page 8 of 24