Mutsy nexo Manual De Instrucciones página 20

inside of the bumper bar to remove the
bumper bar from the frame.
Place the hood (p)
· Press the clips of the hood on the cor-
rect location on the frame. The hood is
fixed on the tubes of the frame. (p1)
· Subsequently, attach the fabric of the
hood to the top of the back support us-
ing the studs. (p2)
adjust the hood (q)
· Hold the front hood bar in the centre
and move it forwards or rearwards to
adjust the hood (q1)
· Open the zipper in the centre of the
opened hood in order to enlarge it. (q2)
· Close the zipper to again reduce the
hood.
· Pull the flap on the front side of the
hood outwards to additionally enlarge
the hood. Push the flap inwards to
again reduce the hood.
remove the hood (r)
· Release the studs at the top of the seat
(r1). Then press the lip (r2) at the bot-
tom of the clips of the hood inwards
and remove the hood.
assemble the rain cover on the pushchair (s)
· Make sure that the hood of the push-
chair is in the upright position.
· Possibly open the zipper in the rain
cover to adapt it to the enlarged hood
of the pushchair.
· Place the rain cover from top to bot-
tom over the pushchair and make sure
that the rain cover is attached well
behind the back support and over the
footrest.
The 5-point safety harness (u)
· Place your child in the pushchair and
make sure that the legs of your child are
15
placed on each side of the leg piece.
· Make sure that the hip and shoulder
belt is positioned correctly over your
child and place both plastic clamps in
the central part of the harness attached
to the leg piece.
· In order to adapt the length of the
shoulder belts, you release the shoul-
der protection from the belt by pull-
ing the Velcro loose. The straps of the
belt are now free in order to adapt the
length. You adapt the length by sliding
the straps over the shoulder belts un-
til both shoulder belts properly harness
your child. Slide the strap down to make
the belt longer. Move the strap upwards
to make the belt shorter. This will cre-
ate a loop in the belt. Hold on to the
strap and pull the clamps to take the
loop out of the belt again. Attach the
shoulder protection to the belt again on
both sides after adjustment by pressing
the velcro together again.
· The back support contains three posi-
tions for the shoulder belts. Release
both shoulder belts by inserting the fas-
tening rings at the rear of the back sup-
port through the openings. Look for the
fastening ring through the fabric (v1).
Tilt it and push it through the opening.
(v2)
· Move the attachment rings through the
desired openings so that the shoulder
belts are positioned properly.
· In order to adjust the position of the leg
piece, open the upholstery under the
seat by pulling the velcro loose. The
fastening ring of the leg piece is located
at the bottom of the seat between the
seat and the elastic. You can tilt the fas-
tening ring with your hand and push it
through the opening to adjust it.
· Regularly check the length and position
of the belts and adjust, where neces-
sary.
English