The Wheels P; The Brake P; The Push Bar; The Pushchair Seat - Mutsy nexo Manual De Instrucciones

English
· You can carry the frame from the push
bar when the folding safeguard has
been locked.
The wheels
assemble the rear wheels (e)
· Slide the axle of the rear wheel in the
rear wheel casing until you hear a
click.
· Pull the wheel to check that it has
been attached firmly.
Disassemble the rear wheels (f)
· Press the button at the back side of the
rear wheel casing and take the wheel
off the frame
assemble the front wheels (g)
· Slide the axle of the front wheel up-
wards in the front wheel casing until
you hear a click.
· Pull the wheel to check that it has been
attached firmly.
Disassemble the front wheels (g)
· Push the button on the back side of the
front wheel (g1) and pull the wheel
from the front wheel casing. (g2)
The swivelling wheels (h)
· Turn the ring above the front wheel out-
wards on both sides in order to block
the swivel setting. The swivelling
wheels will automatically be locked
when the wheels are placed in the rear
direction.
· Turn the ring above the front wheel on
both sides inwards to unlock the swivel-
ling wheels.
The brake (i)
· Push the brake pedal downwards with
your foot to block the rear wheels.
· Push the brake pedal upwards with
your foot to unblock the rear wheels.
14
The push bar (j)
· The push bar has three different height
positions. Press the height adjustment
buttons (j1) and move the push-bar
higher or lower while keeping the but-
tons depressed.
· Release the button when the push bar
is in the desired position.
The pushchair seat (0 months up to 15 kg)
· The pushchair seat is suitable for chil-
dren from 0 months and upwards, up to
15 kg. The back support and leg sup-
port are adjustable. Make sure that the
frame has been fully unfolded and the
brake is blocked during all actions in-
dicated below.
adjust the back support (m)
· The button for adjusting the back sup-
port is located at the rear of the back
support.
· Pinch the button and continue pressing
it while moving the back support back-
wards to lower the back support. Re-
lease the button when the back support
has reached the desired position.
· Pinch the button and continue pressing
it while moving the back support for-
wards to bring the back support in an
upright position. Release the button
when the back support has reached the
desired position.
adjust the leg support (n)
· Lift the leg support to place it upwards.
· Pull the tube (n1) at the bottom of the
leg rest to lower it again.
attach and remove bumper bar (o)
· To secure the front bumper, press the
ends of the bumper into the recesses
(o1) intended for this purpose on the
frame until you hear a click.
· Press the unlock buttons (o2) on the