Fronius Dc Box 60/12 Installation; Dowels And Screws; Selecting A Location - Fronius DC Box 60/12 Manual De Instrucciones

Fronius DC Box 60/12 Installation

Dowels and Depending on the surface, different dowels and screws may be required
Screws for installing the Fronius DC Box 60/12. Therefore, these dowels and
screws are not part of the scope of delivery for the Fronius DC Box 60/12.
The installer is responsible for selecting the proper dowels and screws.
Selecting a
When selecting the location, please observe the following criteria:
Location
-
-
-
-
-
Install on a solid surface.
The ambient temperature may not fall below -25 °C nor exceed +55 °C.
The Fronius DC Box 60/12 may be installed outside in sheltered
areas. Avoid direct contact with moisture.
Should be protected from direct sunlight and direct exposure to the
elements.
Should be installed under the solar modules where possible.
NOTE! To prevent warping
of the Fronius DC Box 60/
12, the device should be
installed only on a flat
surface.
8