Optional Connections - Tripp-Lite SmartOnline Manual Del Usuario

Installation
3
Turn your UPS ON:
• Press the "ON/TEST" Button
• Hold it for several seconds until you hear
a beep
• Release it
Your UPS will begin providing AC power to
its outlets. The "ON LINE" LED will
illuminate.
Note: UPS system will function properly upon
initial startup; however, maximum runtime for the
unit's battery will only be accessible after it has
been charged for 24 hours.

Optional Connections

Your UPS will function properly without these connections.
1
Phone Line or Phone/Network
Line Surge Suppression
Your UPS has jacks which protect against
surges on a phone line. Select models
feature jacks which also protect against
surges on a network line.* Using
appropriate telephone or network cords
connect your wall jack to the UPS jack
marked "IN." Connect your equipment to
the UPS jack marked "OUT." Make sure the
equipment you connect to the UPS's jacks
is also protected against surges on the AC
line.
* Not compatible with PoE (Power Over Ethernet)
applications.
2
USB and RS-232 Serial
Communications
Use the included USB cable (see
or DB9 serial cable (see
the communication port of your computer
to the communication port of your UPS.
Install on your computer the Tripp Lite
PowerAlert Software appropriate to your
computer's operating system. Your UPS may
feature additional communications ports;
these ports may be connected to additional
computers that have PowerAlert Software
installed. Consult your PowerAlert manual
for more information.
201102199 93-2471.indb 5
3
1
2a
) and/
2b
) to connect
2a
2b
5
Your model may differ.
Your model may differ.
Your model may differ.
3/30/2011 9:14:01 AM