Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Recommendations on
Installation
Provide an ample amount of space around
the display
• To prevent internal heat buildup from sealing off the
display, make sure to ensure proper ventilation by leaving
open the minimum amount of space around the display, as
illustrated below.
• The ambient temperature must be 0 °C to 35 °C (32 °F to
95 °F). Be careful when installing the display near a
ceiling. The temperature there can become much higher
than the normal, lower-level room temperature.
• Regarding the installation of hardware such as brackets,
screws, or bolts, we cannot specify the products. Actual
installation is up to the authorized local dealers. Consult
with qualified Sony personnel for installation.
• While the display is on, a certain amount of heat builds up
inside. This can cause burns. Avoid touching the top or
rear of the display when it is powered on or just after it has
entered standby mode.
• This unit weighs about 94kg (207.2 lb.). Make sure the
crane or other lifting equipment to be used during
installation has a sufficient load capacity.
When mounting the display horizontally
Front
10
(4
)
Light sensor/Remote control sensor
Side
7
25 (9
/
)
8
10
(4
)
7
25 (9
/
)
8
5 (2
)
Units: cm (inches)
When mounting the display vertically
Front
25
7
(9
/
)
8
Make sure
that the 1
(POWER)
switch is at
the lower
left.
Light sensor/Remote control sensor
Side
7
20 (7
/
)
8
25
7
(9
/
)
8
10 (4
)
5 (2
)
Units: cm (inches)
3
GB
GB
Publicidad
Tabla de contenido
