Troubleshooting - Schumacher Electric XM1-5 Manual Del Usuario

15. TROUBLESHOOTING

PROBLEM
Charger will not turn
on when properly
connected.
CHARGING
is flashing.
POSSIBLE CAUSE
AC outlet is dead.
AC POWER
is not lit.
Poor electrical con-
nection. AC POWER
LED is not lit.
Severely discharged,
but otherwise good,
battery.
Clips are not making
a good connection
to the battery.
CONNECTED
LED is not lit.
Battery is defective.
Reverse connections at
battery. CONNECTED
LED is not lit.
The charger is in
LED
Abort Mode.
LED
13
• •
REASON/SOLUTION
Check for an open
fuse or circuit breaker
supplying the AC outlet.
Check the power cord
and extension cord for
a loose fitting plug.
The battery may not
want to accept a
charge due to a run-
down state. Allow the
charging to continue
until the battery has had
a chance to recover
sufficiently enough to
take a charge. If more
than 20 minutes, stop
charging and have the
battery checked.
Check for poor
connection to battery
and frame. Make sure
connection points are
clean. Rock clips back
and forth for a better
connection.
Have the battery
checked.
Unplug the charger
and correct the lead
connections.
See "Aborted Charge"
in the OPERATING
INSTRUCTIONS
Section.