How To Use The Memory Function; To Delete All Values Stored In The Memory - Medel CHECK Manual Del Usuario

EN

4.4 How to use the memory function

•
•
4.5 T3 Function. (The average is calculated upon last 3 readings measured within
15 minutes).
1. Press O/I button and take the first measurement.
2. At the end of the first measurement wait at least 5 minutes in a relaxed posi-
3. At the end of the second measurement wait at least 5 minutes in a relaxed
4. At the end of the third measurement press T3 button to perform the average
NOTE:
The average data using T3 button is shown only if the last 3 measurements have
been done within 15 minutes. Otherwise, the data will be shown as 0.

4.6 To delete all values stored in the memory

In Clock mode (Off mode) press MEM button, after the latest data stored will be
displayed press again and hold the MEM button for 3 sec. All results will be
deleted. Press the MEM or O/I button to turn off the display (pic. 17).
28
100042_MEDEL CHECK USER MANUAL_ ALL LANGUAGES.indd 28
is displayed. In this case the results of the measurement have deviated from a
normal situation. Then the measurement needs to be repeated. In the majority
of cases, this is not cause for concern. If the symbol "
(for example several times a week during different daily measurements) it is
advisable to discuss it with your medical advisor (pic. 12).
tion. Then repeat the measurement following step 1 again.
position. Then repeat the measurement following step 1 again.
of the last three measurements taken (the AVG symbol will appear) (pic. 16).
" appears regularly
16/05/2016 09:47:00