How To Use The Memory Function; To Delete All Values Stored In The Memory - Medel CHECK Manual Del Usuario

is displayed. In this case the results of the measurement have deviated from a
EN
normal situation. Then the measurement needs to be repeated. In the majority
of cases, this is not cause for concern. If the symbol "
(for example several times a week during different daily measurements) it is
advisable to discuss it with your medical advisor (pic. 12).

4.4 How to use the memory function

•
•
4.5 T3 Function. (The average is calculated upon last 3 readings measured within
15 minutes).
1. Press O/I button and take the first measurement.
2. At the end of the first measurement wait at least 5 minutes in a relaxed posi-
tion. Then repeat the measurement following step 1 again.
3. At the end of the second measurement wait at least 5 minutes in a relaxed
position. Then repeat the measurement following step 1 again.
4. At the end of the third measurement press T3 button to perform the average
of the last three measurements taken (the AVG symbol will appear) (pic. 16).
NOTE:
The average data using T3 button is shown only if the last 3 measurements have
been done within 15 minutes. Otherwise, the data will be shown as 0.

4.6 To delete all values stored in the memory

In Clock mode (Off mode) press MEM button, after the latest data stored will be
displayed press again and hold the MEM button for 3 sec. All results will be
deleted. Press the MEM or O/I button to turn off the display (pic. 17).
28
100042_MEDEL CHECK USER MANUAL_ ALL LANGUAGES.indd 28-29
5. ERROR MESSAGE/MALFUNCTION
Follow the below recommended actions and press O/I button again to initiate
" appears regularly
another measurement.
Error code
5.1 Other possible malfunctions:
The display shows the
symbol
The blood pressure
values displayed are
abnormally high or
low.
Possible cause(s)
E 1
Deflation is too fast or the cuff
doesn't inflate
E 2
Deflation is too slow
E 3
The cuff pressure is excessive
E 20
The reading process cannot
detect the heart beat
E 21
Inaccurate reading
E Exx
There is a calibration problem
Problem Possible cause(s)
Batteries are drained.
The cuff is not wrapped
correctly or not at the
level of the heart.
Too much stress is ap-
plied on your shoulder
or arm.
You move your arm
or arm muscles during
measurement.
EN
Recommended Action
Re-apply the cuff and try again
Relax for a moment and try again
Movement can compromise the
measurement.
Relax for a moment and try
again .
Loosen the clothes on the arm and
try again
Relax for a moment and try again
Repeat the reading. If the problem
persists, contact the Service
Centre. Refer to the warranty for
the contact information and the
instructions concerning returns.
Recommended Action
Replace all batteries
with new ones.
Wrap the cuff correctly
and rise your hand so
that the cuff is at the
same level of your heart.
Relax yourself and make
measurement.
Remain still and do
not move /contract the
muscles during measure-
ment.
29
28/06/2017 10:31:31