Simplebus; Simplebus Top; Setting The Call Mode; Simplebus - Standard Call Mode (Default) - Comelit FT SB 09 Hoja Técnica

1A
2 connect the keystone jack to the terminal;
3 set the type of system as follows:
OPERATION
Configuration mode has
NAME DIRECTORY
been accessed (see point 3
ACCESS CONTROL
in FT SB 09, page 11).
SETTINGS
Select the CALL
CALL OPERATING
OPERATING/SETTINGS

* SIMPLEBUS

menu.

SIMPLEBUS TOP

Select the desired system CALL OPERATING
mode * SIMPLEBUS
using the keys. SIMPLEBUS TOP
CALL OPERATING
Press the key to
* SIMPLEBUS
confirm the selection.
SIMPLEBUS TOP
1B
DISPLAY DESCRIPTION
During this setup stage,
make sure that the audio
or audio/video keystone
jack is also
programming mode.
4 Next, set the call mode (see point 9.2 "Setting the CALL MODE", page 13) as follows:
OPERATION
Select the desired call
mode
using the keys.
Press the key to
confirm the selection.
5 When the setting procedure is complete, set the programming slide control back to
its standby position (switch in (white) position, see Fig. 1B, page 13).

12.2) Setting the CALL MODE

12.2A) SIMPLEBUS - STANDARD call mode (default).
In this operating mode, the door-entry phone user is identified by a User Name field and
a Code field no longer than 3 digits (between 1 and 240).
in
EXAMPLE: User name = Smith; Code = 1
12.2B) SIMPLEBUS TOP - STANDARD call mode
In this operating mode, the door-entry phone user is identified by the User Name field
(optional) and a Code field consisting of two parts: zone field with no more than 3 digits
(between 1 and 500) and a user field which must have 3 digits (between 1 and 240).
EXAMPLE: User name = Smith; Code = 25 015;
FT SB 09
DISPLAY DESCRIPTION
* STANDARD
INDIRECT CODES
ALPHANUMERIC
* ALPHANUMERIC
IMMOTEC STAND.
IMMOTEC INDIRECT
13
FT SB 09