Installing Batteries; Date/Time Set Procedure - HoMedics BPW-040 Manual De Instrucciones

INSTALLING BATTERIES

1. The battery cover is located
along the left side of the
monitor. Remove battery
cover by pressing down
and pulling away from the
monitor.
2. Install batteries according to
the polarity indications inside
the compartment (as shown
in fig. 2). Battery Type: 2
Alkaline LR03 (AAA) size
3. Replace the cover
by inserting it back
into place.
Replace the batteries if:
1. The weak battery
symbol appears in
the display.
2. Nothing appears in the
display when the power is
switched on.
Replace all batteries at one time (as simultaneous
set). Use only 1.5V AAA alkaline batteries.
Remove batteries when unit is not in use for
extended periods of time. Date and time will need
to be reset if batteries are removed or replaced.
Clean contacts on battery and in battery
compartment with a soft dry cloth each time you
install batteries.
11
BPW-040_A.indd 13-14 BPW-040_A.indd 13-14
Note: Batteries are hazardous waste. Do not dispose of
them together with the household garbage.
1.

DATE/TIME SET PROCEDURE

1. To adjust the date/time, press the Set button
. The display will show a blinking number
showing the month.
2. Change the month by pressing the
2.
Each press will increase the number by one in a
cycling manner. Press the Set button
to confirm the entry, and the screen will show
a blinking number representing the day of the
month.
3. Change the date and time as described in
Step 2 above, using the
the numbers and the Set button
3.
the entries.
repeat process to set date and time
button.
again
button to change
to confirm
Press the button
blinking month
increasing month
confirm the entry
12
12/22/09 12:37 PM 12/22/09 12:37 PM