Publicidad
Idiomas disponibles
Idiomas disponibles
OIL
CHECk THE OIL LEvEL EvERy SIx MONTHS. THE OIL CAPACITy
IS AbOUT 0.3L. RESTORE THE FLUID LEvEL TO 5MM bELOW
THE TOP; THIS MUST bE DONE WITH THE FORkS IN THE LOW-
ERED POSITION.
Use hydraulic oil ISO vG 32 or equivalent.
Oil viscosity should be 30cSt at 104°F (40°C).
HOW TO ExPEL AIR FROM THE PUMP UNIT
Air may enter the unit over time or when the seals are
replaced. To expel the air, lift the control lever to the
LOWER position and move the handle up and down
several times.
For safe operation of the pallet truck, read all warning
signs and instructions here and on the pallet truck prior to
use.
1.
Do not operate the pallet truck unless you are familiar
with it and have been trained and authorized to do so.
2. Do not use the truck on sloping ground.
3. Never place any part of your body in the lifting
mechanism or under the forks or load. Do not carry
passengers.
4. We advise that operators should wear gloves and
safety shoes.
Figure 2
PAGE 2 OF 6
Maintenance
DAILy CHECk AND MAINTENANCE
Daily checks of the pallet truck can limit wear and tear
on the unit. Pay special attention to the wheels, axles,
handle, forks and lift and lower controls.
LUbRICATION
Use motor oil or grease to lubricate all moveable parts.
safety
5. Do not handle unstable or loosely stacked loads.
6. Do not overload the truck.
7.
8. The capacity of the truck assumes an evenly
9. Make sure that length of the forks matches the length
10. Lower the forks to lowest height when the truck is not
A
Always center loads on the forks, not at the end of the
forks. (See Figure 2)
distributed load with the center of the load being at
the halfway point of the length of the forks.
of the pallet load.
being used.
B
0214 IH-2185
Publicidad
