Stryker ComfortGel Manual De Uso página 13

C C l l e e a a n n i i n n g g
W W A A R R N N I I N N G G
• Do not wash the internal components of this support surface. Discard the support surface if a contamination is found
inside.
• Do not immerse the support surface in cleaning or disinfectant solutions.
• Do not allow liquid to pool on the support surface.
• Always inspect support surface covers (top and bottom) for tears, punctures, excessive wear, and misaligned zippers
each time the covers are cleaned. If compromised immediately remove the support surface from service and replace the
covers to prevent cross-contamination.
• Always perform preventative maintenance more often based on the usage level of the product. An increase in product
use may include more frequent cleaning and disinfection, which may affect the life of the support surface.
• Always make sure that you wipe each product with clean water and dry each product after you clean. Some cleaning
agents are corrosive in nature and may cause damage to the product. Failure to follow these cleaning instructions may
void your warranty.
C C A A U U T T I I O O N N
• Do not allow liquid to seep into the zipper area or watershed cover barrier when you clean the underside of the support
surface. Fluids allowed to come in contact with the zipper may leak into the support surface.
• Do not iron, dry-clean, or tumble dry the support surface covers.
• Do not power wash the support surface as this may cause malfunction and damage the product.
• Always dry the support surface covers before you store, add linens, or place a patient on the surface. Dry the product to
help prevent the performance of the product from impairment.
Always follow hospital protocol for cleaning and disinfecting.
To clean the support surface covers between patient uses, follow these steps in order:
1. Use a clean and soft cloth with a mild soap and water solution to remove foreign material from the support surface
covers.
2. Wipe the support surface covers with a clean, dry cloth to remove excess liquid or cleaning agent.
3. Check that the product is dry.
2850-109-005 Rev A.0 9 EN