Lamborghini Caloreclima 310 PM/M-E Manual Para La Instalacion Y El Mantenimento página 28

Never cover up the burner room's air vents, the burner's fan's air-intake openings or any existing air ducts
or air gratings, thus avoiding:
- the formation of poisonous/explosive mixtures of gases in the burner room;
- combustion with insufficient air, which would be dangerous, costly and cause pollution.
The burner must at all times be protected from rain, snow and freezing.
The room where the burner is housed should be kept clean at all times, and there should be no volatile substan-
ces in the vicinity, substances which could be sucked into the fan and could block up the internal ducts of the
burner or combustion head. Dust can be extremely harmful, particularly when it gets onto the fan blades as this
can reduce ventilation and lead to pollution during combustion. Dust can also build up on the rear of the flame
stability disk inside the combustion head, leading to a poor air-fuel mixture.
The burner must be fed with the type of fuel for which it was designed, as indicated on the data plate and in the
technical characteristics given in this manual.
The fuel feed line must be sealed and must be of the rigid variety, with an interposed metal expansion bend with
either a flange joint or a threaded joint.
Furthermore, the feed line must be equipped with all the adjustment and safety devices required by the local
regulations in force.
Particularly ensure that no foreign bodies get into the feed line during installation.
Ensure that the electrical power supply used conforms to the technical characteristics indicated on the data
plate and in this manual.
In accordance with current regulations, the electrical system must be connected to an efficient earth system.
The earth cable must be a couple of cm longer than the phase and neutral wires. Should there be any doubts,
the verification should be made by qualified persons.
Never exchange neutral and live wires.
The burner can be connected up to the mains supply using a plug connection only if the latter is of the kind that
does not allow neutral and live wires to be reversed. Upstream of the equipment, install an omnipolar switch
with an opening between contacts of at least 3 mm, as required by the laws in force.
The entire electrical system, and in particular cable cross-sections, should conform to the maximum absorbed
capacity indicated on the data plate and in this manual.
Should the burner's mains cable be found faulty, it must only be replaced by qualified persons.
Do not touch the burner with parts of the body wich are wet or when in bare feet.
Do not pull (stretch) the mains cables and keep them well away from heat sources.
The length of the cables used must enable the burner to be opened, as well as the boiler door.
After removing the packaging materials, check the content integrity and make sure that no damages have occu-
red during transportation. In case of doubt, do not use the burner and contact the supplier.
The packaging material (wooden cages, cartons, plastic bags, foam, clips, etc...) are potential sources of pollu-
tion and danger, if left lying around; they should be collected up and disposed of in the correct way (in a suitable
place).
UK
28