Torch Neck; Troubleshooting - Abicor Binzel AUTC 61GD Instructivo De Servicio

MAG

9.2 Torch neck

10 Troubleshooting

Problem Cause
Torch becomes too • Contact tip / Tip adapter loose
hot
• Power connections loose on the torch
• Coolant flow too low
No push-button • Control lead interrupted / defective
function
• Flow switch in the re-circulating
Wire burned solid • Wrong parameters set
in the contact tip
• Worn-out contact tip
• Adjust wire burn-back function
Irregular wire feed • Liner clogged
• Contact tip and wire
Tab. 9 Troubleshooting
4 Clean wire conduit (4) from both sides with compressed air.
5 Slide adjusted liner (8) into wire conduit (4) and secure with nut (6).
 See Fig. 3 Mounting the cable assembly on the machine side on
page EN-10
6 Connect cable assembly on the machine side with wire feed unit (7).
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle using the ABICOR BINZEL
anti-spatter agent.
3 Check wearing parts for visible damage and replace them, if required.
NOTE
• Some problems are listed below, with descriptions of possible causes
and solutions. If the measures described below are not successful,
please consult your dealer or the manufacturer.
• Please also consult the operating instructions for the welding
components, such as the power supply, welding torch system etc.
side and toward the work-piece
cooling unit was triggered.
diameter not tuned to one another
10 Troubleshooting
Solution
• Check and tighten
• Check and tighten
• Check cooling system, increase
coolant flow
• Check/repair
• Check coolant level and top up, if
necessary
• Check or correct setting
• Replace
• Correct
• Clean both directions with
compressed air or replace it, if
necessary
• Replace contact tip
EN - 15