Publicidad
Idiomas disponibles
Idiomas disponibles
3a. Using T-30 torx, remove screw/bolt or plastic fastener from
trim bezel.
3b. Repeat step for opposite side.
4a. Open car door.
4b. Using pry tool, remove trim bezel. Use caution in removing
to avoid damage to attachment clip.
4c. Repeat steps for opposite side.
5a. Pull away carpet and foam liner.
5b. Cut marked "T-Slot".
5c. Repeat steps for opposite side.
Corvette Windbreak
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
T-SLOT
MARK
REVISION
AUTH
6a. On seat belt tower, mark a verticle line through the center of
the fastener slot where the fastener was just removed.
6b Using drill, 1/4" drill bit and shop vac, align drill bit tip to slot
and vertical line and begin drilling. While drilling, have
another person use the shop vac to vacuum the debris.
Then use 5/16" drill bit to drill at the same location to
enlarge the hole and last use the 3/8" drill bit to finish the
hole. Using the (3) different size drill bits will ensure the
hole will be drilled at the marked center line.
6c. Using a rubber mallet, tap the screw grommet into the hole
and fully seat.
6d. Repeat steps for opposite side.
REV 22AU08
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Windbreak
PART NO.
88966629
6200 Grand Pointe Dr., Grand Blanc, MI 48439
88966629
SHEET
2
SHEET
2
15
OF
15
OF
Publicidad
