JANE SMART Manual De Instrucciones página 6

EN
IMPORTANT- Read these instructions carefully before use
and keep them for future reference
1
2
3
4
5
a
5
b
CLICK
5
c
CLICK
5
d
6
ASSEMBLING THE PORTABLE CARRYCOT
1 Use the zips to attach the plastic reinforcements around the perimeter of your
SMART carrycot.
ATTENTION: This step should never be performed with the baby inside the carrycot.
Risks from sharp edges and getting ngers and other body parts caught or squeezed by
the carrycot are inevitable during this step.
ATTACH TO THE PUSHCHAIR
This carrycot should always be used with the pushchair cover and seat.
2 Remove the safety bar, position the pushchair's backrest and footrest horizontally
and always activate the brake before attaching or removing your SMART carrycot.
3 Position your SMART carrycot so that your baby's head is on the opposite side of
the handlebar.
4 Adjust the cot (E) to position your baby's head at the right angle.
5 SMART is equipped with adjustable straps (D) so that you can attach the carrycot
to your pushchair.
First tie the straps so that the strap is as vertical as possible on each side of the
pushchair, to do this, pass the fastening clasp through the ring on the strap as
shown in diagram 5a and then fasten the clasp found on the carrycot with the strap
previously attached to the pushchair 5b.
And lastly, pass the straps found below the carrycot through the holes for the
shoulder straps found higher up the pushchair and fasten them 5c.
Adjust the length of the strap with the buckle if necessary 5d.
CAREFUL! Before use, make sure that the buckles on both sides are securely anchored
and that the carrycot is securely fastened to the pushchair.