Rational Combi-Duo Manual De Instalación Original página 12

en
of the front panel. To protect the front
panel against tipping, put a nut on the
bolts on the front left.
13. Insert the left side panel. The side
panel is pulled around the edge to the
rear side of the frame. Secure the left
side panel to the rear side of the
Combi-Duo frame with 1 screw
[ Photo 10].
14. If an Ethernet cable is to be connected
to the top unit, connect the cable be-
fore assembling the exhaust pipe for
better accessibility.
15. Place the heat protection cover on the
bottom part of the exhaust pipe so
that the connections on the rear side
of the top unit are protected against
heat [ Photo
16. Place the exhaust pipe on the exhaust
vents of the bottom unit
[ Photo 12].
17. Place the bracket on the exhaust vents
of the top unit and the exhaust pipe
[ Photo 13].
Turn the door handle of the bottom unit
1. Disassemble the door handle of the
bottom unit: Remove the plastic cover
of the door lock on the inner side of
the door, by sliding the cover towards
the inner side of the door and taking it
out.
2. Loosen the screws of the door handle
with a 5 mm Allen key.
3. Pull the door handle off, turn it 180
degrees and reattach the door handle.
4. Apply the plastic cover.
12 / 72
11].
80.51.370_iCombi Pro-iCombi Classic_CD E_IM_V02_EU-west
5 | Installation