Ocultar thumbs Ver también para Tango+:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

View

Use to modify the display settings.
Waveform
Display:
Graph Display: Choose the measurement you want to view in the Graph view:
BP Reset After:
BP Shrink
After:
New Patient:
Choose the type of waveform that will be displayed:
K-sound: This will display the Korotkoff sounds detected by
the Orbit-K cuff microphone. Choose this for normal
operation.
ECG: Choose this when you are checking for a proper
triggering signal.
Note: ECG waveform is not for patient diagnosis. ECG
waveform will automatically reset to the K-sound mode
after 60 seconds.
HR, DP , or SpO
Set how long the last BP displays. Choose between (in minutes)
1, 2, 3, 5, 10 or select Never to always display the last BP .
Set how long the last BP displays in a larger font. Choose
between (in minutes) 1, 2, 3, 5, 10 or select Never to always
display the larger font.
Set how the monitor prepares for a new patient:
Auto: The system automatically prepares for a new patient.
Prompt: The system will ask you if you have a new patient.
To prepare the monitor for a new patient, Tango+ will do the
following:
• Set back to the Initial Inflate Pressure
• The Main Measurement View will display "---" for all
parameters until they are measured
• The Graph View will not display any data points.
.
2
17

Publicidad

Tabla de contenido
loading

Tabla de contenido